8. [Port Settings] Menu (continued)
5
BRIDGE MODE SETTING SCREEN
5-93
M Voice Reception Control from the EXT Device
Set the input audio control details for the [EXT1]/[EXT2] port.
Note: Appears only when “Voice Data Detection” is selected in [Valid Timing].
q Attack Time ……………… Enter the TX delay time. (Default: 50)
Range: 5 to 2000 milliseconds in 5 milliseconds step
It is the delay time before the VOX switch turns ON after an audio signal is
received through the network.
w Release Time …………… Select the RX delay time in 5 milliseconds step. (Default: 200)
Range: 5 to 2000 milliseconds
It is the delay time for the VOX switch to turn OFF after no audio signal is
received through the network.
e Voice Delay ……………… Set the audio signal buffer time to prevent intermittent audio in 5 milliseconds
step. (Default: 5)
Range: 0 to 500 milliseconds
r Voice Threshold ………… Set the voice threshold level. (Default: 40)
Range: 0 to 100 %
The VOX function automatically switches between receive and transmit
according to this threshold level.
Lower values make the VOX function more sensitive to the audio signal.
[Port Settings]–[EXT Input 1 (EXT1)/EXT Input 2 (EXT2)]
To Next Page
Loading...
