Icom VE-PG3 - M Bridge Communication

5
BRIDGE MODE SETTING SCREEN
5-104
8. [Port Settings] Menu (continued)
M Bridge Communication
Configure the encryption of Bridge communication.
q Encryption ………………… Select “Enable” to encrypt the communication. (Default: Disable)
• When you select "Enable," enter the appropriate key to [Encryption Key].
Note: This setting takes effect when AMBE+2 codec is used.
w Default Callee ID ………… Select “Enable” to apply the ID to the TX signal. (Default: Disable)
• When you select “Enable,” enter the IDs in the bellow items.
e Call Type ………………… Select the type of call. (Default: Group)
• Individual : Call only specified radio.
• Group : Call all radios that belong to the specified group.
• All : Call all radios.
r Destination Prefix ID …… Enter the destination prefix ID in two digits.
ID range: (Depending on the system mode)
t Destination ID …………… Enter the destination ID in four digits. (Default: 1)
ID range: (Depending on the system mode)
y My Station Prefix ID ……… Enter the station prefix ID in two digits.
ID range: (Depending on the system mode)
u My Station ID …………… Enter the station ID in four digits. (Default: 1)
ID range: (Depending on the system mode)
[Port Settings]–[Emergency Notice]
* Appears when “Enable” is selected in [Default Callee ID].
*