Icom VE-PG3 - M V;Roip Incoming Call Setting

6
CONVERTER MODE SETTING SCREEN
6-45
• This is an example.
M V/RoIP Incoming Call Setting
Set the callee destination for each phone number set on the [V/RoIP] Menu.
q Phone Number …………… Displays the phone number (Contract Line Number (PSTN), IP Phone
Number (IP line) or SIP URI user name (Peer to Peer)).
w Line ………………………… Displays the line type.
e Receive Port ……………… Select the extension number (dial-in service) or extension group number of
the device (port), when a call to the set number is received.
(Default: Not used)
r Ringtone ………………… Select the ring tone type when receives a call.
Note: This item takes effect when “SIP Phone(KX-UT Series)” is selected in
the [Port Type] item on the [Extension Connect] screen.
t Queuing …………………… Select “Enable” to use the Receive Queuing function.
Note: This item appears when “LINE” is selected as the line type.
The Receive Queuing function returns the RBT response status while the
callee’s line is busy, to keep calling until the callee’s line is open.
y <Apply> …………………… Click to apply the change.
u <Reset> …………………… Click to restore the settings.
• You cannot restore after clicking <Apply>.
8. [Extension Connect] Menu (continued)
[Extension Connect]–[Incoming Call]