Icom VE-PG3 - M Snmp

5
BRIDGE MODE SETTING SCREEN
5-115
10. [Management] Menu (continued)
M SNMP
Set the SNMP (Simple Network Management Protocol) when you monitor the protocol, to automatically monitor
using the SNMP monitor.
[Management]–[SNMP]
q SNMP ……………………… Select whether to enable or disable the SNMP monitor function.
(Default: Enable)
• If you select “Enable,” you can monitor the VE-PG3’s information with the
SNMP monitor.
w Get Community ……………
Set an ID of up to 31 characters, which is required for the access to the SNMP
monitor. (Default: public)
e System Location ……………
Enter a location name of up to 127 characters to be displayed on the SNMP
monitor.
• The SNMP monitor is compatible with MIB-II (RFC1213).
r System Contact ……………
Enter a contact information of up to 127 characters to be displayed on the
SNMP monitor.
• The SNMP monitor is compatible with MIB-II (RFC1213).