6
CONVERTER MODE SETTING SCREEN
6-75
9. [Port Settings] Menu
!4 PTT-ON Tone …………… Select the DTMF tone to start the transmission. (Default: 0)
• The transmission is started when the selected tone signal is detected.
• If the selected DTMF tone is same as that of selected in [PTT-OFF], the
transmission and reception toggles every time the tone is detected.
!5 PTT-OFF Tone …………… Select the DTMF tone to return to the reception. (Default: 0)
• The transmission is stopped when the selected tone signal is detected.
• If the selected DTMF tone is same as that of selected in [PTT-ON], the
transmission and reception toggles every time the tone is detected.
!6 Call Control Type ………… Select the Audio Transmission Method. (Default: VOX)
• VOX: Sends the audio signal and enables the PTT, when the input audio
signal level exceeds the threshold level.
• SQL: Sends the audio signal and enables the PTT, while receiving a signal
(the squelch is open).
M Transceiver Control (continued)
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
M DTMF Call Setting
Use DTMF Call ……………… Select “Enable” to use DTMF signaling. (Default: Disable)
* Appears only when “DTMF” is selected in [PTT Control Type from the Telephone].
** Appears only when “IC-FR5000/FR6000” or “General” is selected in [Transceiver Model].
*
*
!5
!6
**
To Next Page
Loading...
