Icom VE-PG3 - Page 260

6
CONVERTER MODE SETTING SCREEN
6-74
9. [Port Settings] Menu
!1 Send Connect Failure Tone Select “Tone 1” to “Tone 3” to notify that the calling IP phone is unavailable.
(Default: Notice Tone 3)
!2 Notice Tone Volume ……… Select the tone level for above items. (Default: 0)
Range: "+6” to “–12” (dB)
PTT Control Type from the Telephone
!3 PTT Control Type ………… Select the input signal type to control the transceiver to transmit.
(Default: VOX)
• VOX: The transceiver transmits and communication
route is connected when an audio input is
detected.
• DTMF: The transceiver transmits and communication
route is connected when a DTMF tone signal
is detected.
• PTT Always-ON: The VE-PG3 always sends the PTT control
signal to the radio to transmit.
• PTT Always-OFF: The VE-PG3 doesn’t send the PTT control
signal to the radio.
• Always Send during Talking: The VE-PG3 keeps sending the PTT control
signal, once the communication route has
been established.
M Transceiver Control (continued)
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
* Appears only when “DTMF” is selected in [PTT Control Type from the Telephone].
** Appears only when “IC-FR5000/FR6000” or “General” is selected in [Transceiver Model].
*
*
!5
!6
**