Icom VE-PG3 - M Voice Transmission Control to the Digital Transceiver

6
CONVERTER MODE SETTING SCREEN
6-90
9. [Port Settings] Menu (continued)
M Voice Transmission Control to the Digital Transceiver
The VOX (voice operated transmission) function automatically switches the connected transceiver to transmit,
when the VE-PG3 receives the audio signal through the network.
q Attack Time ……………… Select the TX attack time. (Default: 50)
Range: 0 to 1000 milliseconds
It is the delay time before the VOX switch turns ON after an audio signal is
received through the network.
w Release Time …………… Select the RX delay time in 5 millisecond step. (Default: 500)
Range: 5 to 2000 milliseconds
It is the delay time for the VOX switch to turn OFF after no audio signal is
received through the network.
e Automatic Voice Delay … Select “Enable” to automatically adjust the audio delay, depending on the
network delay time. (Default: Enable)
r Voice Delay ……………… Set the audio signal buffer time to prevent intermittent audio in 5 millisecond
step. (Default: 500)
Range: 0 to 500 milliseconds
t Voice Threshold ………… Set the voice threshold level. (Default: 40)
Range: 0 to 100 %
The VOX function automatically switches between receive and transmit
according to this threshold level.
Lower values make the VOX function more sensitive to the audio signal.
[Port Settings]–[Digital Transceiver1 (D-TRX1)–Digital Transceiver4 (D-TRX4)]