Icom VE-PG3 - M IP Address

5
BRIDGE MODE SETTING SCREEN
5-11
4. [Network] Menu (continued)
M IP Address
Enter the addresses.
q IP Address ………………… Enter the LAN IP address according to your network environment.
(Default: 192.168.0.1)
Note: When using the DHCP Server function, the network part of the IP
address must be the same as that set in the [IP Pool Start Address]
item in the [DHCP Server] menu. (+P5-13)
w Subnet Mask ……………… Enter the subnet mask according to your network environment.
(Default: 255.255.255.0)
( Setting example: When you set the subnet mask to “255.255.255.248”)
• IP address can be set between “192.168.0.0” and “192.168.0.7.”
• IP address for network devices can be set between “192.168.0.2” and
“192.168.0.6.”
• The following IP address cannot be used for network devices.
192.168.0.0 : Network address
192.168.0.1 : VE-PG3 IP address
192.168.0.7 : Broadcast IP address
e Default Gateway ………… If a default gateway device (such as a router) is connected to the LAN port,
enter the device’s IP address.
• If the default gateway is set to the LAN side, the network route is on the
WAN side when the default gateway is set to the WAN side.
[Network]–[IP Address]