Icom VE-PG3 - M Status Detection

6
CONVERTER MODE SETTING SCREEN
6-25
7. [V/RoIP] Menu (continued)
M Status Detection
Configure the details for telephone line.
q Dial Tone Detect ………… Select “Enable” to detect the dial tone signal. (Default: Enable)
w Caller Connect …………… Select the detection type when the callee telephone’s handset is picked up.
(Default: RBT Stop)
e Caller Disconnect ………… Select the detection type when the callee telephone is put on. (Default: BT)
r Callee Disconnect ……… Select the detection type when the callee telephone is put on.
(In the case of the call was initiated by the callee.) (Default: BT)
t Line Cut …………………… Select “Enable” to detect when the telephone line is disconnected.
(Default: Enable)
[V/RoIP]–[LINE Settings]