Icom VE-PG3 - M Controller Connection

5
BRIDGE MODE SETTING SCREEN
5-102
8. [Port Settings] Menu (continued)
M Controller Connection
Configure the connection to IP1000C.
q Controller Address ……… Enter the IP1000C’s IP address.
w Controller Port Number … Enter the service port number which is set in the [Service Port Number] item
on the [Additional Controller Settings] screen of the IP1000C.
(Default: 32000)
Range: “2” to “65534” (only even numbers)
e Local Port Number ……… Enter the destination IP1000C’s service port number which is set in the
[Destination Port Number] item on the [Additional Controller Link] screen of
the IP1000C. (Default: 32010 (Controller 1)
32012 (Controller 2)
32014 (Controller 3)
32016 (Controller 4))
Range: “2” to “65534” (only even numbers)
r Connection Status ……… Displays the connection status.
[Port Settings]–[Controller 1–Controller 4]
r
Wireless access point
An example of communicating using IP1000C
Radio A
Radio A1
IP100H
IP1000C
VE-PG3
IP
Network