Icom VE-PG3 - Connect with the VE-PG3 Using Telnet; M for Windows 7; M about the Telnet Commands

8
FOR YOUR INFORMATION
8-4
M For Windows 7
q
Start up Windows.
w
Click the [Start] button, and then click [Run...].
Input “Telnet.exe” to the text box, and then click <OK>.
e
The telnet screen appears, then input “open” and VE-PG3’s IP address (example: 192.168.0.1).
r
Input login ID and password, then push [Enter].
login ID : “admin” (Fixed)
password : (Input the VE-PG3’s administrator password)
t
If the telnet can access to the VE-PG3, “VE-PG3 #” is displayed on the telnet screen.
M About the telnet commands
The following commands can be used for the Telnet function.
Command list ……………… Push the [Tab] key to display the telnet command list.
After typing a telnet command, push the [Tab] key to display the sub command
list.
Command help …………… After typing "help," enter a command to display the command description.
Example) "help save" ("save" command description is displayed.)
Automatic complement … After typing first few characters of the command, push the [Tab] key. The rest
of the characters for the command are automatically entered.
Example) "n" + [Tab] -> network
Suggested commands are displayed.
Example) "res" + [Tab] -> reset restart
2. Connect with the VE-PG3 using Telnet