Icom VE-PG3 - M Routing Table; M Static Routing; M List of Static Routing Entries

5
BRIDGE MODE SETTING SCREEN
5-15
4. [Network] Menu (continued)
M Static Routing
Enter the static routing destinations. You can enter up to 32 entries.
M List of Static Routing Entries
• This is an example.
• This is an example.
[Network]–[Static Routing]
q Destination ……………… The network address of the route's destination network.
w Subnet Mask …………… The subnet mask of the route's destination network.
e Gateway ………………… The route’s gateway address.
<Add> ………………………… Click to add the setting to [List of Static Routing Entries].
q Destination ……………… The network address of the route's destination network.
w Subnet Mask …………… The subnet mask of the route's destination network.
e Gateway ………………… The route’s gateway address.
r Route …………………… The routing interface.
• lo0: Loop back interface
• vr0: Static IP or DHCP client (WAN)
• pppoe0: PPPoE (WAN)
• mirror0: LAN
t Owner …………………… The type of routing path.
• static: Static route
• misc: Broadcast frame
• host: Host route
<Delete> …………………… Click to delete the entry.
M Routing Table
Displays the routing information.