Icom VE-PG3 - M Bridge Control

6
CONVERTER MODE SETTING SCREEN
6-116
9. [Port Settings] Menu (continued)
M Bridge Control
Configure the details for bridge-connected device.
q Priority Receive ………… Select “Enable” to keep receiving, even if the transceiver detects audio from
the SIP phone. (Default: Enable)
w PTT Cancel ……………… Select “Enable” to abort the calling to an IP phone when a transmit request is
detected. (Default: Disable)
e Target Availability Check …
Select “Disable” to skip the communication availability check. (Default: Enable)
If “Enable” is selected, the VE-PG3 disconnects the communication route
when a call (except Emergency call) from telephone to IP1000C is failed.
The availability check fails when the called IP100H is busy, or no response is
received (Time out timer: 5 seconds).
r Timing of
Target Availability Check … Select “Before” to execute the Target Availability Check (e) before the
communication route is established. (Default: After)
Notice Tone to the Transceiver
t Reception Notice ………… Select “Tone 1” to “Tone 3” to notify that the call from an IP phone is received.
(Default: Not used)
y Calling Notice Tone ……… Select ”Tone 1” to ”Tone 3” to notify the calling to an IP phone.
(Default: Notice Tone 2)
u Send Connect Success Tone
Select “Tone 1” to “Tone 3” to notify that the IP phone’s handset is taken off.
(Default: Notice Tone 2)
[Port Settings]–[Bridge 1–Bridge 4]
*Appears when “G.711u Signaling” is selected in the [Voice Coding] item.
!3
!4
*
*