Icom VE-PG3 - About the Automatic Restore Function

7
MAINTENANCE
7-9
You can clone the VE-PG3’s settings saved in a USB flash drive to other VE-PG3.
About the USB flash drive
• The USB
flash drive
is not supplied. Purchase separately.
• A USB flash drive such as one with biometric authentication, or one with password protection is not supported.
• Turn OFF the VE-PG3’s power before inserting or removing the USB flash drive, to prevent data corruption.
• Either one of the USB slots accepts the USB flash drive, but insert only one USB flash drive at a time.
• Inser the USB flash drive securely.
• NEVER remove the USB flash drive or turn OFF the VE-PG3’s power, while transferring data. It will cause data
corruption, or damage the USB flash drive. While transferring data, the [PWR/MSG] LED blinks.
• After the firmware updating is complete, check the firmware version on the setting screen to verify that the
update was correctly done.
• When importing setting data from the USB flash drive to the VE-PG3, the originally programmed setting data is
automatically saved as “bakdata.sav” in the USB flash drive, as a backup.
Supported USB specification
Interface : USB2.0
Device : USB flash drive (USB Mass Storage Class)
File format : FAT16/FAT32 (exFAT and NTFS are not supported.)
7. About the Automatic Restore function
(Continued on the next page.)