5
BRIDGE MODE SETTING SCREEN
5-72
8. [Port Settings] Menu (continued)
M Transceiver Control
Set the transceiver control details for the [TRX1]/[TRX2] port.
q Priority Receive ………… Select “Enable” to keep receiving, while the transceiver detects the received
audio. (Default: Disable)
w
Audio Transmission Methods to the Transceiver
Select the Audio Transmission Method.
"General Setting"
(Default: VOX)
Other than "General Setting"
(Default: RTP)
• VOX: Sends the audio signal and enables the PTT, when the
input audio signal level exceeds the threshold level.
• RTP: Sends the audio signal and enables the PTT, while receiving
the RTP packet.
"General Setting"
• PTT Always-on :
The VE-PG3 always sends the PTT control signal to the radio to transmit.
"General Setting"
• PTT Always-off :
The VE-PG3 doesn’t send the PTT control signal to the radio.
e Audio Detection Methods from the Transceiver
…………………………… Select the Audio Detection Method (Default: VOX)
• VOX: According to the input audio signal level.
• SQL: According to the squelch status (Open/Close).
• Always Receive: Always in the receive mode.
Note: When "IC-F5060/F6060" (default) is selected in [Transceiver Model],
this item is fixed to "VOX."
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
*Appears only when “SQL” is selected in [Audio Detection Methods from the Transceiver].
*
i
To Next Page
Loading...
