Icom VE-PG3 - Page 132

5
BRIDGE MODE SETTING SCREEN
5-70
M Transceiver 1 (TRX1)/Transceiver 2 (TRX2)(continued)
"General Setting"
8. [Port Settings] Menu
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
@3 Data Bits
Select the number of bits for the serial communication between 5 and 8.
(Default: 8)
@4 Parity
Select a parity bit of [none], [odd], or [even]. (Default: none)
@5 Stop Bits
Select the stop bit length for the data of 1 or 2. (Default: 1)
@6 Connection Status
Displays the connection status. Click "Connection" to connect the serial com-
munication.
@7 Session Timer
Set the time to cut the TCP session when there is no communication from the
host. (Default: 30)
Setting range: 0 to 86400 seconds
*The timeout does not occur when “0” is set.
*
1
Appears only when “Enable” is selected in [Power Detection].
*
2
Appears only when “Enable” is selected in [Serial Communication].
*
3
Appears only when “Enable” is selected in [Transceiver Control].
*
1
*
1
*
2
*
2
*
3
*
2
*
2
*
2
*
2
*
2
!4
!9
@0
@1
@4
@4
@5
@5
@6
@7
@3
@3
@2
@2
Client Mode = "Enable"
Data Mode = "Manual"
!5
!5
!6
!6
!7
!7
!8