LevelOne GEL-5261 - Page 50

– 50 –
Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
Table 4: Switch Main Menu (Continued)
Menu
Description
Page
the transmit and receive counts for any static or system configured
Tunnel
IEEE 802.1Q (QinQ) Tunneling
156
Configure Global
Sets tunnel mode for the switch
160
Configure Interface
Sets the tunnel mode for any participating interface
163
Protocol
164
Configure Protocol
165
Add
Creates a protocol group, specifying supported protocols
165
Show
Shows configured protocol groups
165
Configure Interface
166
Add
Maps a protocol group to a VLAN
166
Show
Shows the protocol groups mapped to each VLAN
166
MAC-Based
168
Add
Maps traffic with specified source MAC address to a VLAN
168
Show
Shows source MAC address to VLAN mapping
168
MAC Address
171
Dynamic
Configure Aging
Sets timeout for dynamically learned entries
173
Show Dynamic MAC
Displays dynamic entries in the address table
171
Clear Dynamic MAC
Removes any learned entries from the forwarding database and clears
entries
172
Learning Status
Enables MAC address learning on selected interfaces
174
Static
Configurea static MAC addresses
176
MAC Notification
178
Configure Global
Issues a trap when a dynamic MAC address is added or removed
178
Configure Interface
Enables MAC authentication traps on the current interface
178
Spanning Tree
181
Loopback Detection
Configures Loopback Detection parameters
183
STA
Spanning Tree Algorithm
Configure Global
Configure
Configures global bridge settings for STP, RSTP and MSTP
185
Show Information
Displays STA values used for the bridge
190
Configure Interface
Configure
Configures interface settings for STA
191
Show Information
Displays interface settings for STA
196