Matrix ETERNITY NE System Manual 233
• Configure “DHCP Server” of SARVAM UCS in the “Network Parameters”. The DHCP Server of SARVAM
UCS will be used for assigning the ‘Auto Provisioning Server Address’ and ‘Server Port’ to the Open SIP
Phone.
If you are using third party DHCP Server in your LAN, see “Using any third party DHCP Server in your
LAN”.
• Configure the SIP Extension General Parameters in SARVAM UCS. For details, see “Configuring SIP
Extension General Parameters” in “SIP Extensions”.
51
• Configure the device specific settings applicable to your Yealink at Location1 on the SIP Extensions page.
To do so,
• Click SIP Extensions.
• Click Device Settings - Location1 to expand and configure the following parameters.
51. Some of the parameters may not be applicable depending on the Open SIP Phone you have connected. Please refer the specific
Open SIP Phone manufacturer’s documentation for more details.
Parameter Description/Action to be Taken
Applicable Open SIP Phone
Variant
Enable Device Select the Enable Device check box.
1. Yealink SIP-T19P/SIP-
T21P/T22P/T26P/T28P/T4X
2. Yealink SIP-T20P
3. Yealink SIP-T3XG
Location
Name
Configure the Location Name to identify the
Open SIP Phone. The Location Name can be a
maximum of 18 characters. Default: Blank.
1. Yealink SIP-T19P/SIP-
T21P/T22P/T26P/T28P/T4X
2. Yealink SIP-T20P
3. Yealink SIP-T3XG
Device Type
Select Device Type as any of the desired
Yealink Open SIP Phone you want to connect
and click Submit to save.
1. Yealink SIP-T19P/SIP-
T21P/T22P/T26P/T28P/T4X
2. Yealink SIP-T20P
3. Yealink SIP-T3XG
MAC Address
Enter the MAC Address of the Yealink phone
to be connected at this location. Default: Blank.
SARVAM UCS validates the phone on the
basis of the MAC Address, and provides
configuration on validation.
1. Yealink SIP-T19P/SIP-
T21P/T22P/T26P/T28P/T4X
2. Yealink SIP-T20P
3. Yealink SIP-T3XG
To Next Page
Loading...
