Matrix ETERNITY NE System Manual 61
If you want to change the Network Settings or Server Settings, press Yes key. Detailed instructions for
changing the Network Settings of the phone are provided at the end of this topic. See “Network Settings” at
the end of this topic.
• The phone makes DHCP Discovery and fetches its IP Address and Server Address from the DHCP
Server.
On getting the IP Address and Server Address, the phone initiates Auto Configuration to download the
configuration files from ETERNITY NENX.
• As the phone downloads the configuration files, the file names will appear one by one.
• On successful download of all configuration files, the phone attempts to register with ETERNITY NENX.
• On successful registration, the phone will display the current day, date and time, the extension number and
name assigned to the Extended IP Phone.
Network Settings
You can change the network settings of the Extended IP Phone. Press the Down key when the phone is in idle
state.
To navigate the menu,
• Press the Menu Key when the phone is idle.
• Scroll by pressing the Up/Down Navigation Key to reach the desired Menu option.
• Press the Select / OK Key to select the desired Menu option.
• Scroll by pressing the Up/Down Navigation Key to reach the desired sub-menu option.
• Press the Select / OK Key to select the desired sub-menu option.
To exit menu,
• Press Cancel Key.
or
Go ON-Hook.
The cursor is a non-blinking underscore that appears under the first letter of the first option in the menu. To make a
selection in the menu, you must move the cursor in the desired direction using the Up, Down, Forward and Back
key. When the cursor is at the desired position, press Enter key to make a selection.
Accessing Network Settings
You can access the Network Settings of the Extended IP Phone in any of the following stages:
• During start-up, when the phone prompts you to change the network settings after loading the firmware.
To Next Page
Loading...
