DMTA-10045-01EN, Rev. E, August 2016
Control Functions
85
Changing the Parameters in the PC RF DISP/DOTS (Display/Dots) Menu
The following information is applicable when the BondMaster 600 is set to PC RF
mode and the DISP/DOTS menu key ( ) has been pressed.
RUN
The RUN setting controls the display mode that the probe is currently operating
in (see Figure 5-8 on page 86).
To change the RUN setting, press the A key, and then rotate the knob to the
desired setting.
The RUN setting can also be accessed and changed by pressing the RUN direct
function key ( ) on the left-hand side of the BondMaster 600 front panel,
underneath the knob.
Changing the RUN will also change the availability of functions in the menus
accessed with the MAIN menu key ( ), DISP/DOTS menu key ( ), and
ALARM menu key ( ).
To Next Page
Loading...
