Olympus BondMaster 600 - Changing BOX Alarm Parameters in PC Swept Mode

DMTA-10045-01EN, Rev. E, August 2016
Control Functions 89
ERASE ALL
The ERASE ALL setting allows you to erase all dot locations.
To erase all dot locations, press the D key.
Pressing ERASE ALL immediately erases all dot locations, which cannot be undone.
SET REF (set reference)
The SET REF (set reference) setting allows you to set a reference image for the
BondMaster 600 display screen. This image is viewable after the erase button is
pressed.
To set a reference image for the BondMaster 600 display screen, press the E key.
Alternatively, the set reference parameter can be activated by pressing and
holding the REF SAVE direct function key ( ) until an alert sound is heard.
D ERASE (display erase)
The D ERASE (display erase) setting controls how often the BondMaster 600
display is automatically erased. It is adjustable between zero (off) and 60 seconds,
in 0.1 second increments (fine) by default. Alternatively, you can change the
DERASE adjustment to 1 second (coarse) increments by pressing the Enter key.
When the coarse function is on, the D ERASE setting is underlined, as shown in
Figure 5-10 on page 90.
To change the D ERASE setting, press the A key, and then rotate the knob to the
desired display erase value.
NOTE