Panasonic FP7 Series Command Reference Manual

Name Description
Set when a value outside the range is specified for the parameter.
To be set when the send disable relay is "Send disabled".
To be set when the send request relay of a specified ID is "Request".
Set when executed in an interrupt program.
To be set when a mail transmission setting that has not been specified with the mail transmission
setting instruction or the tool software is specified.
SR9
(CY)
To be set when the instruction is executed while the Ethernet cable is disconnected. The detail
code set in SD29 is "10: Ethernet cable disconnected".
Set when the instruction is the initialization of Ethernet. The detail code set in SD29 is "11:
Ethernet initialization active".
(Note 1) For details of the error codes stored in the system data SD29, refer to "20.2 List of System Data
Registers".
17.26 SMTPcREQ (Mail Send Request)
17-138 WUME-FP7CPUPGR-12

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English