Panasonic FP7 Series Command Reference Manual

17.26 SMTPcREQ (Mail Send Request)
■
Ladder diagram
(Note 1) The above figure shows the case that S1=U100 (built-in ET-LAN in the CPU unit) and S2=U1
(connection number 1) are specified by the UNITSEL instruction. Set a desired value for [S2].
■
List of operands
Operand Description
S Specify the device address where the transfer number (0 to 15) is stored, or a constant.
■
Devices that can be specified (indicated by ●)
Operan
d
16-Bit device:
32-Bit
device:
Integer
Real
numbe
r
St
rin
g
Index
modifie
r
W
X
W
Y
W
R
W
L
W
S
S
D
D
T
L
D
U
M
WI
W
O
TS
C
S
TE
C
E
IX K Ｕ H SF
D
F
" "
S ● ● ● ● ● ● ● ● ●
■
Outline of operation
● This instruction requests to send a mail.
● Before executing this instruction, use the "SMTPcSET" instruction or the programming tool
software "FPWIN GR7" to configure event mail settings.
■
Processing
● The send request relay for the send number that is specified by [S] is turned ON.
● This instruction can be executed when the cable disconnection detection flag (X60) is OFF.
As an execution condition of the instruction, insert a program that checks the status of the
flag (X60). If this instruction is executed when the flag (X60) is ON, the system relay SR9
(carry flag CY) is set and the instruction is terminated without being executed.
● This instruction can be executed when the Ethernet initialization active flag (X61) is OFF. As
an execution condition of the instruction, insert a program that checks the status of the flag
(X61). If this instruction is executed when the flag (X61) is ON, the system relay SR9 (carry
flag CY) is set and the instruction is terminated without being executed.
● This instruction can be executed when the SMTP client preparation done flag (X69) is ON.
As an execution condition of the instruction, insert a program that checks the status of the
17.26 SMTPcREQ (Mail Send Request)
WUME-FP7CPUPGR-12 17-135

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English