Panasonic FP7 Series Command Reference Manual

17.9 NTPcSV (NTP Destination Server Setting Instruction)
■
Ladder diagram
(Note 1) The above figure shows the case that S1=U100 (built-in ET-LAN in the CPU unit) and S2=U1
(connection number 1) are specified by the UNITSEL instruction.
(Note 2) By copying and pasting the following text in the instruction list box of FPWIN GR7, the operand part of
the above program can be input.
NTPcSV "IPv4=192.168.1.1,TIMEZONE=+0000" "DAY0900"
■
List of operands
Operand Description
S1
Starting address of the device area that stores the string data that indicates the parameters for
specifying a server, or a character constant.
S2
Starting address of the device area that stores the string data that indicates the parameters for
specifying time acquisition timing, or a character constant.
■
Available devices (●: Available)
Operan
d
16-Bit device:
32-Bit
device:
(Note 1)
Integer
Real
numbe
r
St
rin
g
Index
modifie
r
(Note 1)
W
X
W
Y
W
R
W
L
W
S
S
D
D
T
L
D
U
M
WI
W
O
TS
C
S
TE
C
E
IX K Ｕ H SF
D
F
" "
S1 ● ● ● ● ● ● ●
S2 ● ● ● ● ● ● ●
(Note 1) Only 16-bit devices can be modified. (Character constants cannot be specified.)
■
Processing
● This instruction sets a destination NTP server and time zone to send a time adjustment
request.
● The NTP server address and the time zone are set in the CPU unit (built-in ET-LAN)
according to [S1].
● The timing of the time acquisition request is set according to [S2].
● The data that is already set in the CPU configuration is invalid and the NTP time acquisition
request is executed at the timing that is specified by this instruction.
17.9 NTPcSV (NTP Destination Server Setting Instruction)
WUME-FP7CPUPGR-12 17-43

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English