Panasonic FP7 Series - Ftpcreq (FTP Client Transfer Request)

17.14 FTPcREQ (FTP Client Transfer Request)
■
Ladder diagram
(Note 1) The above figure shows the case that S1=U100 (built-in ET-LAN in the CPU unit) and S2=U1
(connection number 1) are specified by the UNITSEL instruction.
■
List of operands
Operand Description
S Device address where the transfer number (0 to 15) is stored, or a constant.
■
Devices that can be specified (indicated by ●)
Operan
d
16-Bit device:
32-Bit
device:
Integer
Real
numbe
r
St
rin
g
Index
modifie
r
W
X
W
Y
W
R
W
L
W
S
S
D
D
T
L
D
U
M
WI
W
O
TS
C
S
TE
C
E
IX K Ｕ H SF
D
F
" "
S ● ● ● ● ● ● ● ● ●
■
Outline of operation
● This instruction requests the transfer of the FTP client.
● Before executing this instruction, use the "17.12 FTPcSET (FTP Client Transfer Setting)"
instruction or the programming tool software "FPWIN GR7" to configure HTTP transfer
settings.
■
Operand [S] setting
Setting item Settings
Setting
range
S
Transfer
number
Specify the device address storing a transfer number or a
constant.
0 to 15
■
Processing
● The transfer request relay of the transfer number that is specified by [S] is turned ON.
● This instruction can be executed when the FTP client preparation done flag (X65) is ON. As
an execution condition of the instruction, insert a program that checks the status of the flag
(X65). An operation error occurs if this instruction is executed when the flag (X65) is OFF.
17.14 FTPcREQ (FTP Client Transfer Request)
WUME-FP7CPUPGR-12 17-73