EasyManuals Logo

Panasonic FP7 Series Command Reference Manual

Panasonic FP7 Series
1222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1167 background imageLoading...
Page #1167 background image
19.5 Changing Timer/Counter Set Value in the RUN Mode
19.5.1 Method to rewrite a constant in a program
Set value (constant) in a program
A constant in a program can be rewritten under the following conditions.
Operation mode: RAM/ROM operation only
Rewriting method: (1) Use the tool software
Here is an example of changing the set value of timer 0 from U30 to U50.
1. Place the cursor over the set value for Timer 0 ("U30").
2. Enter a new constant "U50" and press the <return> key.
3. Press <Ctrl> + <F1> keys to execute Convert PBs.
4. Press [Yes (Y)] after a confirmation message is displayed.
Operation and cautions after the change
Timer/counter in operation continues the pre-change operation. The program will start
operating with the changed settings after the next execution condition changes from OFF to
ON.
When a constant in a program is rewritten, the program itself is overwritten. Therefore, when
the unit is switched to another mode and then returned to RUN, or when it is powered off and
then on again, the program is preset with the changed set value.
19.5 Changing Timer/Counter Set Value in the RUN Mode
WUME-FP7CPUPGR-12 19-7

Table of Contents

Other manuals for Panasonic FP7 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic FP7 Series and is the answer not in the manual?

Panasonic FP7 Series Specifications

General IconGeneral
BrandPanasonic
ModelFP7 Series
CategoryController
LanguageEnglish

Related product manuals