EasyManuals Logo

Panasonic FP7 Series Command Reference Manual

Panasonic FP7 Series
1222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1070 background imageLoading...
Page #1070 background image
Example) Relay operation when the cyclic communication start request is made on a
stopped node
All nodes communicating
normally relay (X6C)
EtherNet/IP start/stop
controllable (X6B)
(1)
Cyclic communication normal
node table (*1)
Cyclic communication stop
node table (*1)
(2)
(3)
(Note 1) The state can be checked by the ETSTAT instruction.
(1)
Cyclic Communication Start
Request (EIPSTART)
(2)
Instruction reception
impossible period
(3)
The specified node start is
complete.
Flag operations
Name Description
SR7
SR8
(ER)
To be set when the unit specified by UNITSEL is not the built-in ET-LAN.
To be set when the EtherNet/IP function is set to Not Use in the Ethernet unit configuration.
Set when executed in an interrupt program.
To be set when the value of [n] exceeds 256.
To be set when the address that is specified by [S] + [Number of valid words for [n]] is out of
the device range.
To be set in the case of out-of-range in indirect access (index modification).
17.35 EIPSTART (Cyclic Communication Start Request)
17-182 WUME-FP7CPUPGR-12

Table of Contents

Other manuals for Panasonic FP7 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic FP7 Series and is the answer not in the manual?

Panasonic FP7 Series Specifications

General IconGeneral
BrandPanasonic
ModelFP7 Series
CategoryController
LanguageEnglish

Related product manuals