Code Timing of occurrence
C05F Receive header check: "Network number" check
C05F Receive header check: "PC number" check
C05F Receive header check: "Destination unit I/O number" check
C05F Error in the number of received and written data
C060 Error in written contact data (except 0/1)
C061
Receive header content check: the number of receive data is smaller than the minimum received
bytes that support header content check.
C061 The number of receive data is smaller than the minimum number of receive bytes.
**50
Receive header check: When a value other than 0x5000 is specified for the sub header, the
value consisting of the first byte of the subheader plus 0x80 is inserted in the high byte "**" of the
error code.
■
Flag operations
Name Description
SR7
SR8
(ER)
To be set in the case of out-of-range in indirect access (index modification).
To be set when the destination range is outside the accessible range.
To be set when the slot number [S1] specified with UNITSEL is not 100 (built-in ET-LAN).
When there is not a connection that is specified with the UNITSEL instruction, the
connection is closed.
The device code and the source upper address specified by S1 is out of the range.
The source lower address specified by S2 is out of the range.
The amount of sent data specified by n is incorrect.
The data device in the receiver data area in master unit specified by D1 is incorrect or
exceeds the area.
The device in which results are stored specified by D2 is incorrect.
17.40 RECV (MC Protocol Master)
17-206 WUME-FP7CPUPGR-12
To Next Page
Loading...
Need help?
General
