Code Name Description of error
!71
Exclusive access control
error
A command was executed that cannot be processed at the same time as
the command in progress.
!78 No SD card error No SD card is installed.
!80
Abnormal guarantee data
error
The guarantee data (CRC code) is abnormal.
!81 No valid data error No valid data exists.
!90 Error during logging trace
A command was executed that cannot be processed during logging
trace.
!92 Unsupported SD card error The SD card is not an industrial SD card made by Panasonic.
■
MEWTOCOL7-COM Communication Error Codes
Code Name Description of error
41 Format error A command was received that does not match the format.
42 No support error An unsupported command was received.
60 Parameter error The specified parameter content does not exist or cannot be used.
61 Data error
There are errors in contact, data area, specification of data No., size
specification, range, or format specification.
62 Registration over error
The number of registrations has been exceeded or the unit has been
operated in an unregistered state.
63 PC mode error
A command that cannot be processed was executed in RUN mode or
PROG mode.
71
Exclusive access control
error
A command was executed that cannot be processed at the same time as
the command in progress.
80
Abnormal guarantee data
error
The guarantee data (CRC code) is abnormal.
91
Missing expansion slave
unit error
A slot number has been specified in a range where no expansion slave
unit is mounted.
20.3 Error Codes Table
20-22 WUME-FP7CPUPGR-12