Panasonic FP7 Series - Page 977

Setting item Settings
Setting
range
S1
Transfer setting
number
Specify a transfer setting number.
ID=: Transfer setting number
0 to 15
(Note 1) Transfer setting numbers should be specified from number 0 in ascending order. An error occurs when
transfer setting numbers are not specified in ascending order. If transfer settings have been already
registered, this rule is not applied.
Setting example
Exam
ple 1
S1 “ID=1”
Settings Transfer setting number: 1
Exam
ple 2
S1 “ID=8”
Settings Transfer setting number: 8
■
Operand [S2] setting
● Specify the starting address of the device area that stores the string data that indicates the
parameters for operation setting, or a character constant.
Setting item Settings
S2
Specification of
HTTP server
Specify HTTP servers. (3 digits fixed)
SV0: Server 0
SV1: Server 1
SV2: Server 2
SV3: Server 3
Target and
operation of
transfer
Specify the target (device) and operation (Send or Get) of transfer.
UPLOAD The target is Device, and the operation is Send.
DOWNLOAD The target is Device, and the operation is Get.
UPDOWN The target is Device, and the operation is Send and
Get.
Command used
Specify a command to be used for transfer.
POST: POST command is used
GET: GET command is used
* Only POST can be specified for Upload or Upload and Download.
(Note 1) Input each operation setting parameter separated by a comma ",".
(Note 2) The operation setting parameters cannot be omitted.
Setting example
Exam
ple 1
S2 "SV3,UPLOAD,POST"
Settings HTTP server: 3, Target: Device, Operation: Send (UPLOAD), Command used: POST (Fixed)
Exam
ple 2
S2 "SV0,UPLOAD,POST"
Settings HTTP server: 0, Target: Device, Operation: Send (UPLOAD), Command used: POST (Fixed)
17.17 HTTPcSET (HTTP Client Transfer Setting)
WUME-FP7CPUPGR-12 17-89