Panasonic FP7 Series Command Reference Manual

Setting example
・Mail text example
Example)
DT200 H002D No. of bytes
Data part
Floor A: 25 degrees C.
Floor B: 28 degrees C.
S1="ID5" S2=DT200
DT201
DT202
DT203
DT204
DT205
DT206
H 20(␣)
DT207
DT208
DT209
DT210
DT211
DT212
DT213
DT214
DT215
DT216
DT217
DT218
DT219
DT220
DT221
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
Data part
H 35(5)
H 2E(.) H 43(C)
H 6C(l) H 46(F)
H 6F(o) H 6F(o)
H 20(␣) H 72(r)
H 3A(:) H 41(A)
H 32(2) H 20(␣)
H 65(e) H 64(d)
H 72(r) H 67(g)
H 65(e) H 65(e)
H 20(␣) H 73(s)
H 46(F) H 0D(CR)
H 6F(o) H 6C(l)
H 72(r) H 6F(o)
H 42(B) H 20(␣)
H 20(␣) H 3A(:)
H 38(8) H 32(2)
H 64(d) H 20(␣)
H 67(g) H 65(e)
H 65(e) H 72(r)
H 73(s) H 65(e)
H 43(C) H 20(␣)
H 00 H 2E(.)
Data part
Data part
DT222
DT223
■
Flag operations
Name Description
SR7
SR8
(ER)
To be set in case of out-of-range values in indirect access (index modification).
To be set when the slot number [S1] specified with UNITSEL is not 100 (built-in ET-LAN).
To be set when an out-of-range value is specified for parameters.
Set when executed in an interrupt program.
To be set when the send request of the mail transmission control relay of a target ID number is 1:
Requesting.
To be set when the mail transmission setting for a target ID number is not set with the mail
transmission setting instruction or the tool software.
CY
(SR9)
Set when the instruction is the initialization of Ethernet. The detail code set in SD29 is "11:
Ethernet initialization active".
(Note 1) For details of the error codes stored in the system data SD29, refer to "20.2 List of System Data
Registers".
17.20 SMTPcBDY (Mail Text Setting)
17-104 WUME-FP7CPUPGR-12

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English