Roll Feeder (D503/D504)
SM 3-41 D093/D094
Installation
6. Set the shoes
, , , ,under the main machine.
7. Use a wrench to adjust the nuts [1] on each foot to raise or lower the main machine at each
corner.
The main machine must be level side-to-side within ±0.15/m.
8. Attach the left leg cover [2] and the right leg cover [3].
9. Remove the lock screws [1], [2] (
x 2).
10. Lift the left hinge [3] and right hinge [4] off their support screws then lift the unit to the
vertical position. (Do not remove the support screws.)
11. Put the level [5] on the exposure glass.
12. If the machine is level, you are finished. Be sure to re-attach the lock screws and hinges
removed in Steps 9 and 10.
-or-
To Next Page
Loading...
