Main SP Modes
D093/D094 6-20 SM
2301 Transfer Current Adjustment
Use these SP's to adjust the power output and power coefficient used to transfer
the toner image from drum to paper. Four separate voltages are applied before
the leading edge, at the leading edge of the paper, across the image area and at
the trailing edge of the paper..
Notes:
The coefficient adjustment should be done before the power output.
The amount of voltage applied to each area can be set independently in
each area for the type of paper in use.
Transfer Current Adjustment Table
The four separate voltages for image transfer to paper are applied:
A: Before paper leading edge
B: Leading edge
C: Image area
D: Trailing edge
To Next Page
Loading...
