SP1-xxx Feed
D093/D094 2-2 SM Appendix
2.2 SP1-XXX FEED
1001 Leading Edge Registration
1 1st Roll
Adjusts the leading edge registration for printing. To move the
image down the page, increase the value.
[-10.0 to +10.0/ 0 /0.1 mm step]
2 2nd Roll
3 Cassette
5 By-pass Feed
1002 Side-to-Side Registration
1 1st Roll Adjusts the side-to-side registration for printing.
[-10.0 to +10.0/ 0 /0.1 mm step]
To move the start position to the right, increase the
value (+).
To move the start position to the left, decrease the
value (–).
Note: If you use paper 914 mm wide, adjust within the
range of ±2 mm. If you set the adjustment outside this
range, part of the image will be cut off.
2 2nd Roll
3 Cassette
5 By-pass Feed
1003 Registration Buckle Adjustment – Cassette Feed
This SP eliminates the amount of buckle at the registration roller.
When paper is fed from the paper cassette, before the registration rollers
start to rotate the leading edge of the paper stops and hits the nip of the
registration rollers and stops.
The registration rollers remain idle long enough to stop the paper from
skewing in the paper path.
This SP adjusts the amount of time that the registration rollers remain idle to
reduce paper buckle.
Raise this setting to lengthen the amount of time that the paper pauses at the
nip of the registration rollers if you notice a large amount of skew in printouts.
[-20 to +20 / 5 / 1]
To Next Page
Loading...
