Service Call Conditions
SM 7-13 D093/D094
Trouble-
Shooting
7.2 SERVICE CALL CONDITIONS
There are 4 levels of service call conditions
Level Definition Reset Procedure
A
Fusing unit SC codes shown on the operation
panel. The machine is disabled. The operator
cannot reset the machine.
The machine requires
immediate servicing by a
service technician.
B
These SC codes disable only the features that
use the defective item. The user does not see
these SC codes in usual conditions. But, they
are shown on the operation panel when the
defective feature is used.
Cycle the machine off/on with
the main power switch..
C
SC codes that are not shown on the operation
panel. They are recorded internally.
Recorded only.
D
These SC codes are shown on the operation
panel. To reset these SC codes, turn the
operation switch or main power switch off and
on. These SC codes are shown again if the
error occurs again.
Set the operation switch or the
main power switch to “off” then
to “on”.
To Next Page
Loading...
