Ricoh D093 - Special Adjustments; Image Adjustment with SP Modes; Step 1: Magnification for Paper Type: Plain

Special Adjustments
SM 5-103 D093/D094
Replacement
and
Adjustment
5.12 SPECIAL ADJUSTMENTS
5.12.1 IMAGE ADJUSTMENT WITH SP MODES
Do these adjustments if output is unsatisfactory. Before you start measurements and
adjustments, let the test print output cool for five minutes.
 Do each adjustment in the order described below. Be sure to turn the main machine’s
power off/on after each SP adjustment to enable the new setting.
Step 1: Magnification for Paper Type: Plain
1. Go into the SP mode.
2. Do SP4417, select pattern 28 (Grid Pattern), then touch [OK].
3. Touch "COPY Window".
4. Select the paper size.
5. Set a blank sheet of A1 SEF paper in the original tray.
6. Press [Start] to print a test pattern.
7. Print two more test patterns (you need three grid pattern prints).
8. Refer to the diagram and instruction table below to do the SP magnification corrections (if
needed).