SP1-xxx Feed
SM Appendix 2-35 D093/D094
Appendix:
SP Mode
Tables
1948 Press Roller Inching Target Temp
This SP determines when inching starts.
Inching control is done when the pressure roller temperature is above this
setting (65
o
C for example), but printing is prohibited until the pressure roller
temperature reaches its target temperature.
Inching (idle rotation of the rollers) starts after the temperature rises above
the hot roller target temperature (SP1937 003).
While the temperature is below 65
o
C copying (not printing) is possible before
the temperature of the pressure roller reaches its target temperature and
inching starts.
1 Plain: Mode1 [60 to 180/100/5
o
C]
2 Plain: Mode2 [60 to 180/65/5
o
C]
3 Plain: Mode3
[60 to 180/60/5
o
C] 4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1 [60 to 180/130/5
o
C]
7 Trans.: Mode2 [60 to 180/100/5
o
C]
8 Trans.: Mode3
[60 to 180/60/5
o
C]
9 Trans.: Mode4
10 Trans.: Mode5
11 Film: Mode1
12 Film: Mode2
13 Film: Mode3
14 Film: Mode4
15 Film: Mode5
16 Plain Mode: Low Temp Cold Start
When the machine determines that a cold start in a low-temperature environment
To Next Page
Loading...
