Ricoh D093 - Entering the Cut Length Adjustment; Setting Paper Sizes;Types for the Tray 1 (1 St Roll), Tray 2 (2 Nd Roll)

Roll Feeder (D503/D504)
SM 3-49 D093/D094
Installation
Entering the Cut Length Adjustment
1. Do the settings for SP1920. These are the cut length SP settings for the rolls (there are two
settings for each roll).
2. Check the label on the right side of the roll feeder drawer. Do the settings written on the
label.
Roll SP No. Name
Roll 1 1920-22 Cut Length Adjustment: 1st Roll:297 mm:Plain Paper
Roll 1 1920-26 Cut Length Adjustment: 1st Roll:1189 mm:Plain Paper
Roll 2 1920-82 Cut Length Adjustment: 2nd Roll:297 mm:Plain Paper
Roll 2 1920-86 Cut Length Adjustment: 2nd Roll:1189 mm:Plain Paper
1. Switch the main power switch off, then switch it on again.
Setting Paper Sizes/Types for the Tray 1 (1st Roll), Tray 2 (2nd Roll)
1. Push [User Tools]> “System Settings”> “Tray Paper Settings”> “Tray Paper Size: Tray 1”,
“Tray Paper Size: Tray 2”.
2. Select the paper size for Tray 1 and Tray 2.
3. Push “Next”> “Paper Type: Tray 1”, “Paper Type: Tray2
4. Select the paper type for Tray 1 and Tray 2.