Ricoh D093 - NVRAM Download

Boards
D093/D094 5-94 SM
NVRAM Download
Do this procedure to download the NVRAM data from an SD card to the NVRAM in the
machine.
1. Switch the main power switch off.
2. If a new NVRAM is to be installed, do SP5801-2 to make sure that the new NVRAM is clear.
 After replacing the NVRAM, the total counter should be reset to 0: [User Tools]>
[Counter].
3. Do SP5811 (Machine Serial Number) to set the serial number.
4. Insert the SD card with the NVRAM data in SD card Slot 2.
5. Switch the main power switch on.
6. Go into SP mode and do SP5825 (Download NVRAM Data).
7. Follow the instructions on the operating panel display to execute the download.
8. Switch the main power switch off.
9. Switch the main power switch on.
10. If the Data Overwrite Security Unit has been installed, it must be installed again.
11. Do SP3001-2 to initialize the ID sensor.