Preparation
D093/D094 3-6 SM
Roll Feeder Installation
SP Adjustment
1920 Cut Length Adjustment
Sets the cut length settings for the rolls installed in the roll feeder. These
settings are different for each machine. The settings are on a label attached
to the right side of the roll feeder drawer.
1920-22 Cut Length Adjustment: 1st
Roll: 297 mm: Plain Paper
Adjust for D503/D504, 1st Roll
1920-26 Cut Length Adjustment: 1st
Roll: 1189 mm: Plain Paper
Adjust for D503/D504, 1st Roll
1920-82 Cut Length Adjustment: 2nd
Roll: 297 mm: Plain Paper
Adjust for D504, 2nd Roll
1920-86 Cut Length Adjustment: 2nd
Roll: 1189 mm: Plain Paper
Adjust for D504, 2nd Roll
1001-1 Leading Edge Registration –
1st Roll
Adjust D503/D504, 1st roll.
1001-2 Leading Edge Registration –
2nd Roll
Adjust for D504, 2nd roll.
1002-1 Side-to-Side Registration – 1st
Roll
Adjust for D503/D504, 1st roll
1002-2 Side-to-Side Registration –
2nd Roll
Adjust for D504, 2nd roll.
To Next Page
Loading...
