Development
SM 5-41 D093/D094
Replacement
and
Adjustment
5.4.2 DEVELOPER
1. Remove the development unit (
p.5-40 "Development Unit")
Do not bend the bias terminal.
2. Put the development unit on a large sheet of paper.
3. Remove the casing [A] for the toner supply unit (
x 2)
4. Remove the development filter [B] and bracket [C].
5. Hold the development unit above the paper with the gears up.
6. Turn the paddle roller knob [D] clockwise until all developer is out of the unit.
When disposing of used developer, always obey local laws and regulations
regarding the disposal of such items.
7. Clean the development unit (especially the right end), the development filter, and
development filter bracket.
To Next Page
Loading...
