SP4-xxx Scanner
D093/D094 2-78 SM Appendix
9 Ind. Dot Erase (x1) 1-7 (Weak-Strong)
Sets the level of independent dot erasure to improve the appearance in the
backgrounds of images scanned in the Grayscale mode.
[0 to 7 / 0 / 1]
0: Default (Off) 1 (Weakest) to 7 (Strongest)
4570
Scanner: Color Text/Photo DFU
These SP codes enhance the quality of originals scanned in color in the
Text/Chart mode (selected on the operation panel).
5 MTF : 0(Off) 1-15 (Weak-Strong)
Sets the MTF coefficient scanned in color in the Text/Photo mode. When the
original image is converted to electrical signals, the contrast is reduced due to the
influence that adjacent white and black pixels have on one another as a result of
CIS properties. This may cause very narrow bands or spacing between black and
white areas. Use the MTF adjust to correct this problem and emphasize image
detail.
[0 to 15 / 8 / 1]
0 (Weakest), 8 (Medium: Default), 15 (Strongest)
6 Smoothing: 0 (x1) 1-7 (Weak-Strong)
Sets the level of smoothing for originals scanned in color in the Text/Photo mode.
[0 to 7 / 0 /1 ]
0 (Weakest), 4 (Medium: Default), 7 (Strongest)
7 Brightness:1-255
Sets the overall brightness images scanned in color in the Text/Chart mode.
[1 to 255 / 128 / 1]
1 (Weakest), 128 (Medium: Default), 255 (Strongest)
Note: Raising the brightness level may increase moiré
To Next Page
Loading...
