Ricoh D093 - ID Sensor, Pick-Off Pawls, Pick-Off Pawl Solenoid

Drum
SM 5-51 D093/D094
Replacement
and
Adjustment
5.5.3 ID SENSOR, PICK-OFF PAWLS, PICK-OFF PAWL SOLENOID
1. Drum ( p.5-47 "Drum Unit")
2. Cleaning blade (
p.5-50 "Cleaning Blade")
3. ID sensor [A] (
x 3, x 1, x 1)
4. Pick-off pawls (x2) [B] (pressure release).
5. Pick-off pawl solenoid [C] (
x 2, x 1)
Re-installation
 After replacing or cleaning the ID sensor, do SP3001-2 to initialize the new ID sensor.
 If the ID sensor is damaged and cannot be replaced immediately, set SP2208-3 (Toner
Supply Setting: Toner Supply Mode) to “1”. Then the customer can continue to use the
machine until a new ID sensor is available. After you install a new ID sensor, reset this SP
to 0.