Ricoh D093 - Lower Limit Temp: Press Roller

Main SP Modes
SM 6-13 D093/D094
System
Maintenance
Reference
1936 Lower Limit Temp: Press Roller
This SP sets the minimum difference allowed between the actual temperature
and the target temperature of the pressure roller.
 If the setting for the target temperature of the pressure roller is high
(SP1932), the temperature of the pressure roller is lowered for continuous
printing on plain paper.
 At this time, if the temperature is below the temperature set for the
pressure roller, paper feed will stop during a long job to perform inching to
allow enough time for the pressure roller temperature to rise to the level of
the prescribed setting, and then the job will continue.
Important: Modes "1" to "5" below refer to the paper and thickness settings
selected in User Tools (see "Paper Thickness Default Selection" in this
section).
1 Plain: Mode1
[0 to 50/0/5
o
C]
2 Plain: Mode2
3 Plain: Mode3
4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1 [0 to 50/20/5
o
C]
7 Trans.: Mode2
[0 to 50/0/5
o
C]
8 Trans.: Mode3
9 Trans.: Mode4
10 Trans.: Mode5
11 Film: Mode1
12 Film: Mode2