Ricoh D093 - Connection Timing Adjustment Incoming DFU; Dial up Password DFU; Dial up User Name DFU; Local Phone Number DFU

Main SP Modes
SM 6-69 D093/D094
System
Maintenance
Reference
156
Dial Up User Name DFU
This is the user name for dialing at the access point where Embedded RC
Gate-M is used.
Note: Numbers with spaces or # marks appear enclosed with quotation
marks in the user name.
157
Dial Up Password DFU
This is the password for dialing at the access point where Embedded RC
Gate-M is used.
Note: Numbers with spaces or # marks appear enclosed with quotation
marks in the user name.
161
Local Phone Number DFU
This is the number of the local line where Embedded RC Gate-M is
connected. This is the line used to communicate with the Call Center.
162
Connection Timing Adjustment Incoming DFU
When the Call Center calls out to the access point where Embedded RC
Gate-M is used, the ID tone (*#1#) is sent repeatedly. This SP sets the
amount of time to elapse for ID tone output.
[0 to 24/1/1 pause count]
1 pause count = 2 sec.
163
Access Point DFU
This is the dial-up telephone line number of the access point connected to
Embedded RC Gate-M. If a number is entered here that number is used. If no
number is entered here then the pre-set country setting is used.
164
Line Connecting DFU
This SP code should be set for the customer using Embedded RC Gate-M,
depending on the line usage (whether line is shared with a fax or not).
[0 to 1/0/1]
0: Line shared with facsimile
1: Line not shared with facsimile