Preparation
SM 3-5 D093/D094
Installation
SP and User Tool Settings Required for Installation
This is a summary of the important SP and User Tool settings that are necessary for this
installation.
Main Machine Installation
2801-2 Lot Number 1 Enter the developer lot numbers at
installation before doing SP2801-1
2801-3 Lot Number 2
2801-1 Initialize Developer Mixes developer and supplies toner.
2923-1 Execute Cleaning Blade
Replace Mode
Applies a thin layer of toner to the drum.
This prevents scratches on the drum when
the machine power comes on for the first
time.
3001-2 Initialize ID Sensor Initializes the ID sensor after toner has
been applied to the drum.
User Tool System Settings > Tray
Paper Setting > Next > Paper
Type: Tray n
Sets the paper type for each tray:
Tray 1: Roll 1
Tray 2: Roll 2
Tray 3: Cassette
Bypass
User Tool System Settings > Timer
Settings > Set Date, Set
Time
Check the date and time setting. If they
are not correct, set the correct date and
time.
To Next Page
Loading...
