Main SP Modes
SM 6-61 D093/D094
System
Maintenance
Reference
5811
Machine No. Setting DFU
CTL
This SP presents the screen used to enter the 11-digit number of the machine.
The allowed entries are "A" to "Z" and "0" to "9". The setting is done at the
factory, and should not be changed in the field.
5812
Service Tel. No. Setting CTL
Use these SP modes to input service and support telephone numbers. Enter the
number and press
Press the [./*] key to input a pause. Press the “Clear modes” key to delete the
telephone number.
1 Service Service representative telephone number.
2 Facsimile Fax number of service representative
3 Supply Supplier of consumables
4 Operation Operation support
5816 Remote Service CTL
1
I/F Setting
Turns the remote diagnostics off and on.
[0 to 2/2/1]
0: Remote diagnostics off.
1: Serial (CSS or @Remote) remote diagnostics on.
2: Network remote diagnostics on for @Remote
2
CE Call
Lets the operator engineer start or end of the remote machine check with CSS or
@Remote; to do this, push the center report key
To Next Page
Loading...
