Common Procedures
SM 5-9 D093/D094
Replacement
and
Adjustment
5.1.9 IDLE REGISTRATION ROLLER PANEL
1. Open the upper unit.
2. Side covers. (
p.5-2 "Side Covers")
3. Toner hopper cover (
p.5-8 "Toner Hopper Cover")
4. Disconnect the connector and ground wire [A] (
x 1, x 1).
5. Idle registration roller panel [B] (
x 2)
Remove the two rear screws [C] first and let the panel come down. Use a very short
screwdriver to remove the rear screws.
Disconnect the panel from the stud screw on the right side first [D], then the left side.
Do not remove the stud screws.
To Next Page
Loading...
