Special Adjustments
SM 5-111 D093/D094
Replacement
and
Adjustment
Step 12: Synchro Cut (Trailing Edge Registration)
The following SPs are necessary for this step:
SP4961-1 (Original Adjustment – Synchro Cut Adjustment 210 mm)
SP4961-2 (Original Adjustment – Synchro Cut Adjustment 1000 mm)
SP4961-3 (Original Adjustment – Original Length Display)
1. Prepare two originals
1 original 210 mm long (A4 LEF)
1 original 1000 mm long (measure and cut)
2. Go into the SP mode and do SP4961-1.
3. Touch "COPY Window" and copy the 210 mm sheet that you prepared in Step 1.
4. Touch "SP Mode" to go back to the SP mode.
5. Do SP4961-3 to check the original scan length.
6. If the display is different, adjust with SP4961-1.
7. Do SP4961-2.
8. Touch "COPY Window" and scan the 1000 mm sheet that you prepared in Step 1.
9. Touch "SP Mode" to go back to the SP mode.
10. Do SP4961-3 to check the scan length.
11. If the display is different, adjust with SP4961-2.
Cut Length (mm) Cut Tolerance (mm)
Less than 297 ±4.50
to 594 ±5.00
to 841 ±6.00
to 1189 ±8.50
to 2000 ±18.0
to 3000 ±27.0
to 3600 ±33.0
To Next Page
Loading...
