Ricoh D093 - Page 292

Special Adjustments
D093/D094 5-110 SM
Size Orientation
A Sideways (Eng. 11”)
B Sideways (Eng. 17”)
D Lengthways (Eng. 34”)
E Lengthways (Eng. 44”)
2. Measure the cuts and check them against the standards of this table.
Cut Length (mm) Cut Tolerance (mm)
Less than 297 ±3
420 to 1189 ±5
to 2000 ±6
=3000 ±11
to 4000 ±14
3. If a measurement is not in the standard range of the "Cut Tolerance" in the table above,
adjust SP1920-22 to -130 for each roll, paper width, and paper type.